Welcome!
Termarust HRCSA: Slashing Steel Refurbishment Costs!
Saving #1: Corrosion Mitigation.
Termarust HRCSA’s unique, single coat, 3 step, wet on wet process offers the ability to stop structure critical corrosion – GUARANTEED.
NO MORE RUST BLEEDING!
Saving #2: Overcoating with only 7,000psi-5,000psi pressure washed substrate.
High-pressure water cleaning leaves good tightly-adhered coating behind requiring less overcoating material.
Termarust HRCSA Penetrant/Sealer penetrates deep inside the pack-rust steel interface to stop crevice corrosion inside structure critical joints, connections and free-up corrosion frozen bearings.
Termarust HRCSA ONE-COAT Primer/Topcoat adheres via polar bonding – eliminating the need for a profile.
No profile = more user-friendly / faster deployment.
Saving #3: Slash Containment Costs!
High-pressure water cleaning does not produce micronized, breathable and absorbable dust, so negative air containments are no longer needed.
Field applications confirm that using hot water high-pressure water cleaners (HPWC) results in an initial 80% evaporation of the wash water and secondly in most cases, proper ventilation will take care of the rest leaving collectible paint chips.
If there is recovered wash water it is flocculated, filtered, tested and ether recycled for washing or released.
Reduced Project Hazardous waste management, no waste solvent, no flushing of paint lines you only have for collecting paint chips.
Saving #4: Mitigate Risks of Liquidated Damages with ONE COAT application.
Expedite the application by a) minimizing containment requirements, b) reducing surface preparation efforts, c) slashing coating application times and your crew is in and done in the shortest time possible. d) Fewer traffic detours and lane closures reduce costs as crews are in and out more quickly and efficiently.
Saving #5: Single Component: From container to the steel substrate, no mixing, thinning or catalyzing.
Insert airless paint pump into the paint container and apply non-hazardous single-component SINGLE COAT HRCSA onto clean, dried, steel or tightly adhered contaminant free existing coated surface.
No need to flush paint lines between shifts.
No pot-life limitations for properly stored HRCSA materials. No hazardous waste disposal costs.
HRCSA LC50 96 hour Trout fish-kill 41,017ppm. Dry material can be safely disposed of in a landfill.
Reduce Refurbishment Costs by 47%
The Termarust HRCSA’s user-friendliness and practical nature is not only cost-effective in its application, but if deployed in time is capable of preserving structures which would otherwise have had to have been replaced.
Visit our Case Studies inside the Corrosion mitigation resource center to learn more or send us an email to info@termarust.com
[contact-form][contact-field label=”Name” type=”name” required=”1″][contact-field label=”Email” type=”email” required=”1″][contact-field label=”Message” type=”textarea”][/contact-form]